- Document the virtio random number generator device support - While here, remove mention of the specific FreeBSD version such as 10-STABLE, and just refer to the latest supported release. Signed-off-by: Roman Bogorodskiy <bogorodskiy(a)gmail.com&gt; --- docs/drvbhyve.rst | 21 +++++++++++++++++++-- 1 file changed, 19 insertions(+), 2 deletions(-) diff --git a/docs/drvbhyve.rst b/docs/drvbhyve.rst index f9cb99006e..e93ef0f447 100644 --- a/docs/drvbhyve.rst +++ b/docs/drvbhyve.rst @@ -7,8 +7,10 @@ Bhyve driver .. contents:: Bhyve is a FreeBSD hypervisor. It first appeared in FreeBSD 10.0. However, it's -recommended to keep tracking FreeBSD 10-STABLE to make sure all new features of -bhyve are supported. In order to enable bhyve on your FreeBSD host, you'll need +recommended to use the +`latest supported release <https://www.freebsd.org/releases/>`__ +to make sure all new features of bhyve are supported. +In order to enable bhyve on your FreeBSD host, you'll need to load the ``vmm`` kernel module. Additionally, ``if_tap`` and ``if_bridge`` modules should be loaded for networking support. Also, :since:`since 3.2.0` the ``virt-host-validate(1)`` supports the bhyve host validation and could be used @@ -582,3 +584,18 @@ Note that these extensions are for testing and development purposes only. They are **unsupported**, using them may result in inconsistent state, and upgrading either bhyve or libvirtd maybe break behavior of a domain that was relying on a specific commands pass-through. + +Random number generator device +~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ + +:since:`Since 11.3.0` it's possible to use the virtio random number generator devices. + +Example: + +:: + + ... + <rng model='virtio'> + <backend model='random'/> + </rng> + ... -- 2.49.0