When using --without-$name --without-secdriver-$name with $name being selinux or apparmor, configure will fail saying that AppArmor/SELinux development package must be installed. This is caused by a small bug in --with-secdriver-$name handling in configure.ac which treats --without-secdriver-$name when $name as if the user had requested to enable $name when $name couldn't be detected on the system. This commit also makes sure the detection checks for disabled secdrivers do not needlessly get run, especially as this could cause an error as well in --with-$name --without-secdriver-$name situations. --- configure.ac | 10 ++++++---- 1 file changed, 6 insertions(+), 4 deletions(-) diff --git a/configure.ac b/configure.ac index 8810efd..5ea3bc2 100644 --- a/configure.ac +++ b/configure.ac @@ -1493,10 +1493,11 @@ AC_ARG_WITH([secdriver-selinux], if test "$with_selinux" != "yes" ; then if test "$with_secdriver_selinux" = "check" ; then with_secdriver_selinux=no - elif test "$with_secdriver_selinux" = "yes"; then + fi + if test "$with_secdriver_selinux" != "no"; then AC_MSG_ERROR([You must install the libselinux development package and enable SELinux with the --with-selinux=yes in order to compile libvirt --with-secdriver-selinux=yes]) fi -else +elif test "$with_secdriver_selinux" != "no"; then old_cflags="$CFLAGS" old_libs="$LIBS" CFLAGS="$CFLAGS $SELINUX_CFLAGS" @@ -1571,10 +1572,11 @@ AC_ARG_WITH([secdriver-apparmor], if test "$with_apparmor" != "yes" ; then if test "$with_secdriver_apparmor" = "check" ; then with_secdriver_apparmor=no - else + fi + if test "$with_secdriver_apparmor" != "no" ; then AC_MSG_ERROR([You must install the AppArmor development package in order to compile libvirt]) fi -else +elif test "with_secdriver_apparmor" != "no" ; then old_cflags="$CFLAGS" old_libs="$LIBS" CFLAGS="$CFLAGS $APPARMOR_CFLAGS" -- 1.7.12.1