Re: [libvirt] ideas for custom iptables rules for libvirt networks.

On 04/26/2016 04:15 AM, Daniel P. Berrange wrote: >On Mon, Apr 25, 2016 at 01:48:49PM -0400, Laine Stump wrote: >>We still periodically get requests to allow custom iptables rules for >>libvirt virtual networks (or, more commonly, a mode where libvirt simply >>leaves iptables alone, not adding or removing anything), and it's been a >>nagging item on my to-do list for a very long time. The problem is that, >>although the amount of code required to support *any* solution is very >>small, it's one of those things without a single obvious "only" way to do >>it. Anyway, I'm going to take one more stab at it. >> >> >>First, some background points: >> >>* For <forward mode='nat'> libvirt's iptables rules are essential to the >>operation of the forwarding, so we shouldn't mess with that. >> >>* For [no forward mode], libvirt's iptables rules are a part of what keeps >>the network isolated from the rest of the network, so we shouldn't mess with >>that either. >> >>* For <forward mode='route'> we currently allow all outgoing and incoming as >>long as it is to/from the IP address range defined for the network. >> >>So we really want something that can be used only for <forward mode='route'> >> >>I can see 3 different possibilities: >> >>1) a new forward mode which is just like 'route', but doesn't add any >>iptables rules. (what to call it though? "filterless-route"? Too long and >>ugly :-/) >I'd suggest this and just call it mode='bare' or mode='open', to avoid >implying any specific semantics about the connectivity. Thinking about this more, I'm having disturbing memories of trying to combine multiple knobs into a single attribute in the past, only to have it backfire later (I can't recall anything specific though) - for example although I say right now that there's no reason to skip adding rules for isolated or nat networks, we may come up with a valid use case in the future. For that reason, I think it may be safer to add: <forward mode='route' filter='none'/> (or "manual" as Cole suggested). That way it's still obvious from mode that the traffic will be routed to other networks, and it will be possible to use the filter attribute for other modes (or add other filter settings even for mode='route') in the future. (Validation would be added to make sure that the filter attribute isn't set for any mode other than route). Does that make sense?