On 09/18/2014 09:52 AM, Pavel Hrdina wrote:
We are not detecting the presence of FIPS from QEMU, but from procfs
and
that means it's not QEMU capability. It was decided that we will pass
this flag to QEMU even if it's not supported by old QEMU binaries.
Resolves:
https://bugzilla.redhat.com/show_bug.cgi?id=1135431
Signed-off-by: Pavel Hrdina <phrdina(a)redhat.com>
---
Note: The original bug is that we are not detecting whether libvirtd
binary has been updated, we detect that only for QEMU binary. So you
could update libvirt without updating QEMU and new capabilities that could
already exists in QEMU, but was recently implemented in libvirt wasn't
enabled. I'll post a patch to fix this bug.
src/qemu/qemu_capabilities.c | 24 ------------------------
src/qemu/qemu_command.c | 25 +++++++++++++++++++++++--
2 files changed, 23 insertions(+), 26 deletions(-)
I agree with moving the detection of the bit out of cached capability
bit and delaying it instead to qemu startup time (although it means a
stat() call for every qemu spawned, instead of the former behavior of
checking only once). I also agree with the way you removed setting the
bit in qemu_capabilities.c but not the bit itself (the bit is still
defined and named from qemu_capabilities.h, so that if we upgrade
libvirtd and parse the XML for a running qemu domain that was started
from earlier libvirt, we don't mis-behave when seeing that capability
bit, even if we no longer use it for anything).
However, I still think you need a v2:
+++ b/src/qemu/qemu_command.c
@@ -7656,8 +7656,29 @@ qemuBuildCommandLine(virConnectPtr conn,
if (!standalone)
virCommandAddArg(cmd, "-S"); /* freeze CPU */
- if (virQEMUCapsGet(qemuCaps, QEMU_CAPS_ENABLE_FIPS))
- virCommandAddArg(cmd, "-enable-fips");
+ /* Qemu 1.2 and later have a binary flag -enable-fips that must be
+ * used for VNC auth to obey FIPS settings; but the flag only
+ * exists on Linux, and with no way to probe for it via QMP. Our
+ * solution: if FIPS mode is required, then unconditionally use
+ * the flag, regardless of qemu version, for the following matrix:
+ *
+ * old QEMU new QEMU
+ * FIPS enabled doesn't start VNC auth disabled
+ * FIPS disabled/missing VNC auth enabled VNC auth enabled
+ *
+ * Setting the flag here instead of in virQEMUCapsInitQMPMonitor
+ * or virQEMUCapsInitHelp also allows the testsuite to be
+ * independent of FIPS setting.
+ */
+ if (virFileExists("/proc/sys/crypto/fips_enabled")) {
Ouch. This will make our testsuite differ based on whether it is run on
Linux in FIPS mode (where FIPS might exist) or on any other setup. I
think you need to hoist the check for virFileExists() to the caller, and
pass in the result as a new bool parameter to this function, so that the
testsuite has full control over the boolean without regards to the
current system's level of FIPS support.
--
Eric Blake eblake redhat com +1-919-301-3266
Libvirt virtualization library
http://libvirt.org