Hi All, I am very new to libvirt-cim. We wanted to create a VM using libvirt-cim using CIM schemas. Could you please detail the steps involved in this task, procedures, softwares to be installed and run, docs, wikipages, blogs..etc. Thanks in advance. Best Regards Raghu -----Original Message----- From: libvirt-cim-bounces(a)redhat.com [mailto:libvirt-cim-bounces@redhat.com] On Behalf Of libvirt-cim-request(a)redhat.com Sent: 30 May 2012 10:50 To: Raghunatha Reddy P (raghunp) Subject: Welcome to the "Libvirt-cim" mailing list Welcome to the Libvirt-cim(a)redhat.com mailing list! To post to this list, send your email to: libvirt-cim(a)redhat.com General information about the mailing list is at: https://www.redhat.com/mailman/listinfo/libvirt-cim If you ever want to unsubscribe or change your options (eg, switch to or from digest mode, change your password, etc.), visit your subscription page at: https://www.redhat.com/mailman/options/libvirt-cim/raghunp%40cisco.com You can also make such adjustments via email by sending a message to: Libvirt-cim-request(a)redhat.com with the word `help' in the subject or body (don't include the quotes), and you will get back a message with instructions. You must know your password to change your options (including changing the password, itself) or to unsubscribe. It is: reddy123 Normally, Mailman will remind you of your redhat.com mailing list passwords once every month, although you can disable this if you prefer. This reminder will also include instructions on how to unsubscribe or change your account options. There is also a button on your options page that will email your current password to you.