Re: [libvirt-users] Installing libvirt

Hi, Sorry, I will keep the instructions in mind. I tried ./autogen.sh with --system but there was a version mismatch. I guess someone should write a patch for debian based system.  I tried to install libvirt 1.1.1 with Fedora and when I did make, I got the following error:  Making all in src make[2]: Entering directory `/home/peeyush/Downloads/libvirt-1.1.1/src'   GEN      libvirt_access_lxc.syms /bin/sh: -w: command not found make[2]: *** [libvirt_access_lxc.syms] Error 127 make[2]: Leaving directory `/home/peeyush/Downloads/libvirt-1.1.1/src' make[1]: *** [all-recursive] Error 1 make[1]: Leaving directory `/home/peeyush/Downloads/libvirt-1.1.1' make: *** [all] Error 2 Any idea why am I getting this? Thanks. ~Peeyush Gupta ________________________________ From: Eric Blake <eblake(a)redhat.com&gt; To: Peeyush Gupta <gpeeyush(a)ymail.com&gt; Cc: &quot;libvirt-users(a)redhat.com&quot; <libvirt-users(a)redhat.com&gt; Sent: Wednesday, 31 July 2013 6:19 PM Subject: Re: [libvirt-users] Installing libvirt On 07/30/2013 11:30 PM, Peeyush Gupta wrote: [can you convince your mailer to wrap long lines?  Also, it looks like your mailer is not using proper in-reply-to headers, such that you are spawning a new thread every time you reply] Any reason you went with 1.0.5 instead of the just-released 1.1.1? This defaults into installing things into /usr/local, which does not match the paths your distro normally uses.  Your problems may stem from the fact that because you didn't install it into distro locations, your distro is unable to run libvirtd as a service.  If you run './autogen.sh --system', that helps prepopulate the configure options such as --bindir that are more likely to match your distro layout (I know for sure that ./autogen.sh --system matches Fedora layout, but don't know if Debian-based layout differs, although no one has written a patch complaining otherwise). -- Eric Blake  eblake redhat com    +1-919-301-3266 Libvirt virtualization library http://libvirt.org