[libvirt-users] reset = destroy start

what is different between destroy -> start and reset in virsh? i meet this position , when i reset a domain, it cannot start , it stoped at initialize initd.but when i destory it ,and start it , it can run normally. i am very confuse about them. who can tell me the difference.... thanks a lots.

On 07.04.2013 09:44, 邓焕聪 wrote:
what is different between destroy -> start and reset in virsh?
i meet this position , when i reset a domain, it cannot start , it stoped at initialize initd. but when i destory it ,and start it , it can run normally.
i am very confuse about them.
who can tell me the difference....
thanks a lots.
The 'destroy' kills corresponding qemu process, while 'reset' is like pressing the reset button (virtual in this case). However, what you are describing sounds strange. However, I think this is either SeaBIOS or distro issue. Michal
participants (2)
-
Michal Privoznik
-
邓焕聪