I thought this was in the Virtusalisation Guide, but can't find it there now. Anyway, this is how I got a USB device (printer in this case) passed through to a VM. The same general procedure may work for you: Assuming the USB device is plugged in, powered on and has been recognised by the system, the first step is to locate vendor and product ID information for the device using lsusb: # lsusb Bus 002 Device 001: ID 0000:0000 Bus 001 Device 001: ID 0000:0000 Bus 001 Device 002: ID 1058:1021 Western Digital Technologies, Inc. Bus 004 Device 001: ID 0000:0000 Bus 004 Device 002: ID 046d:c018 Logitech, Inc. Optical Wheel Mouse Bus 003 Device 002: ID 04f9:0033 Brother Industries, Ltd Bus 003 Device 001: ID 0000:0000 The printer information is in the line containing 'Brother Industries, Ltd'. What we need are the hexadecimal numbers 04f9:0033. The next step is to open the XML configuration file for the VM we wish to add this device to, and add the following section (from <hostdev> to </hostdev> inclusive). Notice how the numbers discovered above are added using the hexadecimal 0x prefix: <domain type='kvm'> <name>vm_name</name> ... <devices> ... <hostdev mode='subsystem' type='usb'> <source> <vendor id='0x04f9'/> <product id='0x0033'/> </source> </hostdev> ... </devices> </domain> For this to work, it is necessary that the device in question is not in use on the host. In this case, the printer driver is not installed on the host so all is OK. Otherwise, it may be necessary to remove drivers from the host to be safe. For USB block devices, it is enough to simply not mount a device on the host. Note also that the USB device must be attached to the host when the VM is booted, and remain attached. There is no Plug'n'Play type operation possible with this solution, although it is reportedly possible to enable such functionality. When the VM is started using the modified XML configuration file, running lsusb on that machine should reveal that the USB device has now been passed through from the host to the guest. In this case, printer drivers can now be installed normally on the guest. -----Original Message----- From: libvirt-users-bounces(a)redhat.com [mailto:libvirt-users-bounces@redhat.com] On Behalf Of Tom Stave Sent: Friday, 29 October 2010 10:58 PM To: libvirt-users(a)redhat.com Subject: [libvirt-users] SCSI tape drive device I have a SCSI tape backup unit attached to a kvm host managed by libvirt. Is there a way to expose the SCSI device in libvirt so I could pass the device to a virtual machine and have the virtual machine control the tape backup? Defining the device as a SCSI disk does not appear to work. In this situation, live migration is not an issue. The VM would always be tied to this host. _______________________________________________ libvirt-users mailing list libvirt-users(a)redhat.com https://www.redhat.com/mailman/listinfo/libvirt-users -------------------------------Safe Stamp----------------------------------- Your Anti-virus Service scanned this email. It is safe from known viruses. For more information regarding this service, please contact your service provider.