Hi, I'm examining a domain that's connected to the 'default' network # virsh net-dumpxml default <network connections='1'> <name>default</name> <uuid>c757baa7-2b31-4794-9dfb-0df384575602</uuid> <forward mode='nat'> <nat> <port start='1024' end='65535'/> </nat> </forward> <bridge name='virbr0' stp='on' delay='0'/> <mac address='52:54:00:37:b7:92'/> <ip address='192.168.122.1' netmask='255.255.255.0'> <dhcp> <range start='192.168.122.2' end='192.168.122.254'/> </dhcp> </ip> </network> using a device as follows: <interface type='network'> <mac address='52:54:00:ed:06:2e'/> <source network='default' portid='83db8ca9-baed-47f3-ba0d-1a967ee86aa5' bridge='virbr0'/> <target dev='vnet19'/> <model type='virtio'/> <alias name='net0'/> <address type='pci' domain='0x0000' bus='0x00' slot='0x02' function='0x0'/> </interface> The domain is running but apparently without an IP address: # virsh domifaddr podvm-podsandbox-totok-8f10756a Name MAC address Protocol Address ------------------------------------------------------------------------------- The requisite host-side interfaces look good (to me anyway :-)): 10: virbr0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc htb state UP group default qlen 1000 link/ether 52:54:00:37:b7:92 brd ff:ff:ff:ff:ff:ff inet 192.168.122.1/24 brd 192.168.122.255 scope global virbr0 valid_lft forever preferred_lft forever [...] 35: vnet19: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue master virbr0 state UNKNOWN group default qlen 1000 link/ether fe:54:00:ed:06:2e brd ff:ff:ff:ff:ff:ff inet6 fe80::fc54:ff:feed:62e/64 scope link proto kernel_ll valid_lft forever preferred_lft forever I can share more information about the setup if necessary but I'll stop here for now since I feel this must be just a simple stupid oversight on my part. Please let me know if you'd like to have additional info. Thanks in advance, pvl