12:41 a.m.
Hello all,
Basically my problem is how can i access a virtual machine from local
network. I am able to do so from the host PC put not from other PC's
on the same network.
here is my what i did so far
(http://wiki.libvirt.org/page/Networking#NAT_forwarding_.28aka_.22virtual_...)
cat '/etc/libvirt/qemu/networks/default.xml'
<network>
<name>default</name>
<uuid>1bad08f7-0bc3-bfde-f87d-f323ab1c95eb</uuid>
<forward mode='nat'/>
<bridge name='virbr0' stp='on' delay='0' />
<ip address='10.0.2.1' netmask='255.255.255.240'>
<dhcp>
<range start='10.0.2.2' end='10.0.2.14' />
</dhcp>
</ip>
</network>
cat '/etc/sysctl.conf'
# Disable packet forwarding
#net.ipv4.ip_forward=0
net.ipv4.ip_forward=1
# disable netfilter on the bridge:
net.bridge.bridge-nf-call-ip6tables = 0
net.bridge.bridge-nf-call-iptables = 0
net.bridge.bridge-nf-call-arptables = 0
ifconfig -a
br0 Link encap:Ethernet HWaddr 00:1C:C0:38:AF:BA
inet addr:10.0.1.5 Bcast:10.0.1.15 Mask:255.255.255.240
inet6 addr: fe80::21c:c0ff:fe38:afba/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:580 errors:0 dropped:0 overruns:0 frame:0
TX packets:6 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:29435 (28.7 Kb) TX bytes:468 (468.0 b)
eth0 Link encap:Ethernet HWaddr 00:C0:DF:13:AF:87
inet addr:10.0.1.4 Bcast:10.0.1.15 Mask:255.255.255.240
inet6 addr: fe80::2c0:dfff:fe13:af87/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:476362 errors:0 dropped:0 overruns:0 frame:0
TX packets:684752 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:57147388 (54.4 Mb) TX bytes:707797829 (675.0 Mb)
Interrupt:22 Base address:0x800
eth1 Link encap:Ethernet HWaddr 00:1C:C0:38:AF:BA
inet6 addr: fe80::21c:c0ff:fe38:afba/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1142 errors:0 dropped:0 overruns:0 frame:0
TX packets:43 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:90530 (88.4 Kb) TX bytes:2632 (2.5 Kb)
Memory:e3200000-e3220000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:118356 errors:0 dropped:0 overruns:0 frame:0
TX packets:118356 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:14239239 (13.5 Mb) TX bytes:14239239 (13.5 Mb)
virbr0 Link encap:Ethernet HWaddr FE:54:00:45:A7:31
inet addr:10.0.2.1 Bcast:10.0.2.15 Mask:255.255.255.240
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:180 errors:0 dropped:0 overruns:0 frame:0
TX packets:128 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:16657 (16.2 Kb) TX bytes:50599 (49.4 Kb)
vnet0 Link encap:Ethernet HWaddr FE:54:00:45:A7:31
inet6 addr: fe80::fc54:ff:fe45:a731/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:14 errors:0 dropped:0 overruns:0 frame:0
TX packets:357 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:500
RX bytes:1404 (1.3 Kb) TX bytes:19248 (18.7 Kb)
brctl show
bridge name bridge id STP enabled interfaces
br0 8000.001cc038afba no eth1
virbr0 8000.fe540045a731 yes vnet0
route -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
10.0.1.0 0.0.0.0 255.255.255.240 U 0 0 0 eth0
10.0.1.0 0.0.0.0 255.255.255.240 U 0 0 0 br0
10.0.2.0 0.0.0.0 255.255.255.240 U 0 0 0 virbr0
0.0.0.0 10.0.1.1 0.0.0.0 UG 0 0 0 eth0
iptables -L
Chain INPUT (policy ACCEPT)
target prot opt source destination
ACCEPT udp -- anywhere anywhere udp dpt:domain
ACCEPT tcp -- anywhere anywhere tcp dpt:domain
ACCEPT udp -- anywhere anywhere udp dpt:bootps
ACCEPT tcp -- anywhere anywhere tcp dpt:bootps
Chain FORWARD (policy ACCEPT)
target prot opt source destination
ACCEPT all -- anywhere 10.0.2.0/28 state
RELATED,ESTABLISHED
ACCEPT all -- 10.0.2.0/28 anywhere
ACCEPT all -- anywhere anywhere
REJECT all -- anywhere anywhere
reject-with icmp-port-unreachable
REJECT all -- anywhere anywhere
reject-with icmp-port-unreachable
ACCEPT all -- anywhere anywhere PHYSDEV
match --physdev-is-bridged
ACCEPT all -- anywhere anywhere state
RELATED,ESTABLISHED
ACCEPT all -- anywhere anywhere
ACCEPT tcp -- anywhere 10.0.2.5 tcp dpt:smakynet
ACCEPT all -- anywhere anywhere state
RELATED,ESTABLISHED
ACCEPT all -- anywhere anywhere
ACCEPT tcp -- anywhere 10.0.2.5 tcp dpt:smakynet
ACCEPT all -- anywhere anywhere state
RELATED,ESTABLISHED
ACCEPT all -- anywhere anywhere
ACCEPT tcp -- anywhere 10.0.2.5 tcp dpt:smakynet
Chain OUTPUT (policy ACCEPT)
target prot opt source destination
the IP Address for the virtual machine i am trying to access is
10.0.2.5 (vnet0). I am able only to access it from the host PC only,
therefore, how i can i access it from other PC's on the network ?
Any help would be much appreciated.
--
Sincerely,