Fangge Jin <fjin@redhat.com> writes:
> I can share some test results with you:
> 1. If no memtune->hard_limit is set when start a vm, the default memlock
> hard limit is 64MB
> 2. If memtune->hard_limit is set when start a vm, memlock hard limit will
> be set to the value of memtune->hard_limit
> 3. If memtune->hard_limit is updated at run-time, memlock hard limit won't
> be changed accordingly
>
> And some additional knowledge:
> 1. memlock hard limit can be shown by ‘prlimit -p <pid-of-qemu> -l’
> 2. The default value of memlock hard limit can be changed by setting
> LimitMEMLOCK in /usr/lib/systemd/system/virtqemud.service
Ah, that explains it to me, thank you. And since in the default case
the systemd limit is not reported in <memtune> of a running VM, I assume
libvirt takes it as "not set" and sets the higher limit when setting up
a zero-copy migration. Good.
Not sure whether you already know this, but I had a hard time differentiating the two concepts:
1. memlock hard limit(shown by prlimit): the hard limit for locked host memory
2. memtune hard limit(memtune->hard_limit): the hard limit for in-use host memory, this memory can be swapped out.
Regards,
Milan