Re: non-root bridge set-up on Fedora 39 aarch64

On Tue, Feb 20, 2024 at 10:58:46AM -0800, Andrea Bolognani wrote: > On Tue, Feb 20, 2024 at 10:17:43AM -0500, Chuck Lever wrote: > > On Mon, Feb 19, 2024 at 07:18:06PM -0500, Laine Stump wrote: > > > On 2/19/24 10:21 AM, Chuck Lever wrote: > > > > Hello- > > > > > > > > I'm somewhat new to the libvirt world, and I've encountered a problem > > > > that needs better troubleshooting skills than I have. I've searched > > > > Google/Ecosia and stackoverflow without finding a solution. > > > > > > > > I set up libvirt on an x86_64 system without a problem, but on my > > > > new aarch64 / Fedora 39 system, virsh doesn't seem to want to start > > > > virbr0 when run from my own user account: > > > > > > > > cel@boudin:~/kdevops$ virsh net-start default > > > > error: Failed to start network default > > > > error: error creating bridge interface virbr0: Operation not permitted > > > > > > > > > If you run virsh as a normal user, it will auto-create an unprivileged > > > ("session mode") libvirt instance, and connect to that rather than the > > > single privileged (ie. run as root) libvirt instance that is managed by > > > systemd. Because this libvirt is running as a normal user with no elevated > > > privileges, it is unable to create a virtual network. > > > > > > > > > What you probably wanted to do was to connect to the system-wide privileged > > > libvirt, you can do this by either running virsh as root (or with sudo), or > > > by using > > > > > > > > >   # virsh -c qemu:///system > > > > > > > > > rather than straight "virsh". Whichever method you choose, you'll want to do > > > that for all of your virsh commands, both for creating/managing networks and > > > guests. > > > > These are wrapped up in scripts and ansible playbooks, so I'll have > > to dig through that to figure out which connection is being used. > > Strange that this all works on my x86_64 system, but not on aarch64. > > This makes me very suspicious. There are a few things that differ > between x86_64 and aarch64, but this shouldn't be one of them. > > Are you 100% sure that the two environments are identical, modulo the > architecture? Honestly, what seems a lot more likely is that either > the Ansible playbooks execute some tasks conditionally based on the > architecture, or some changes were made to the x86_64 machine outside > of the scope of the playbooks. It's impossible to say that the two environments are identical. The two possibilities you mention are the first things I plan to investigate.