On 10.01.2015 11:42, Mathieu Bouillaguet wrote:
Hi,
I try to define an iscsi pool with virsh but I always get the following
error :
error :internal error: missing backend for pool type 5 (iscsi)
And yet libvirt was compiled with iscsi support :
configure: Storage Drivers
configure:
configure: Dir: yes
configure: FS: yes
configure: NetFS: yes
configure: LVM: yes
configure: iSCSI: yes
configure: SCSI: yes
configure: mpath: yes
configure: Disk: yes
configure: RBD: no
configure: Sheepdog: no
configure: Gluster: no
configure: ZFS: no
And virsh report that iscsi is supported :
virsh -V
Virsh command line tool of libvirt 1.2.11
See web site at
http://libvirt.org/
Compiled with support for:
Hyperviseurs : QEMU/KVM LXC UML OpenVZ VMWare VirtualBox ESX Test
RĂ©seau : Remote Network Bridging Interface udev Nwfilter VirtualPort
Stockage : Dir Disk Filesystem SCSI Multipath iSCSI LVM
Divers : Daemon Nodedev Secrets Debug Readline Modular
Any idea what's going on ?
I guess the daemon with iSCSI enabled is not running? It's nice that
virsh supports iSCSI, but the actual work with that is done by the
daemon. So make sure you run the daemon which was built by the configure
& make you've shown above.
Michal