According to the code, 'virsh numatune' supports integers for specifying --mode as well as the string definitions "strict", "interleave", and "preferred". However, this possibility was not documented anywhere, so this patch adds it to both the man page and command help. Resolves: https://bugzilla.redhat.com/show_bug.cgi?id=1085706 Signed-off-by: Martin Kletzander <mkletzan@redhat.com> --- tools/virsh-domain.c | 3 ++- tools/virsh.pod | 8 +++++--- 2 files changed, 7 insertions(+), 4 deletions(-) diff --git a/tools/virsh-domain.c b/tools/virsh-domain.c index b5b9f91..5a17aff 100644 --- a/tools/virsh-domain.c +++ b/tools/virsh-domain.c @@ -7823,7 +7823,8 @@ static const vshCmdOptDef opts_numatune[] = { }, {.name = "mode", .type = VSH_OT_DATA, - .help = N_("NUMA mode, one of strict, preferred and interleave") + .help = N_("NUMA mode, one of strict, preferred and interleave \n" + "or a number from the virDomainNumatuneMemMode enum") }, {.name = "nodeset", .type = VSH_OT_DATA, diff --git a/tools/virsh.pod b/tools/virsh.pod index 99d0b74..a5e8406 100644 --- a/tools/virsh.pod +++ b/tools/virsh.pod @@ -1402,9 +1402,11 @@ Set or get a domain's numa parameters, corresponding to the <numatune> element of domain XML. Without flags, the current settings are displayed. -I<mode> can be one of `strict', `interleave' and `preferred'. For a -running domain, the mode can't be changed, and the nodeset can be -changed only if the domain was started with a mode of `strict'. +I<mode> can be one of `strict', `interleave' and `preferred' or any +valid number from the virDomainNumatuneMemMode enum in case the daemon +supports it. For a running domain, the mode can't be changed, and the +nodeset can be changed only if the domain was started with a mode of +`strict'. I<nodeset> is a list of numa nodes used by the host for running the domain. Its syntax is a comma separated list, with '-' for ranges and '^' for -- 2.0.0