All of print function use vshPrintExtra in cmdDomIfAddr, this will make domifaddr no output in quiet mode, after this patch, quiet mode output will be: # virsh -q domifaddr test3 --source agent lo 00:00:00:00:00:00 ipv4 127.0.0.1/8 - - ipv6 ::1/128 ens8 52:54:00:1a:cb:3f ipv6 fe80::5054:ff:fe1a:cb3f/64 virbr0 52:54:00:db:51:e7 ipv4 192.168.122.1/24 virbr0-nic 52:54:00:db:51:e7 N/A N/A Signed-off-by: Luyao Huang <lhuang@redhat.com> --- tools/virsh-domain-monitor.c | 16 ++++++++-------- 1 file changed, 8 insertions(+), 8 deletions(-) diff --git a/tools/virsh-domain-monitor.c b/tools/virsh-domain-monitor.c index 6951db2..9686531 100644 --- a/tools/virsh-domain-monitor.c +++ b/tools/virsh-domain-monitor.c @@ -2278,9 +2278,9 @@ cmdDomIfAddr(vshControl *ctl, const vshCmd *cmd) /* When the interface has no IP address */ if (!iface->naddrs) { - vshPrintExtra(ctl, " %-10s %-17s %-12s %s\n", - iface->name, - iface->hwaddr ? iface->hwaddr : "N/A", "N/A", "N/A"); + vshPrint(ctl, " %-10s %-17s %-12s %s\n", + iface->name, + iface->hwaddr ? iface->hwaddr : "N/A", "N/A", "N/A"); continue; } @@ -2313,12 +2313,12 @@ cmdDomIfAddr(vshControl *ctl, const vshCmd *cmd) /* Don't repeat interface name */ if (full || !j) - vshPrintExtra(ctl, " %-10s %-17s %s\n", - iface->name, - iface->hwaddr ? iface->hwaddr : "", ip_addr_str); + vshPrint(ctl, " %-10s %-17s %s\n", + iface->name, + iface->hwaddr ? iface->hwaddr : "", ip_addr_str); else - vshPrintExtra(ctl, " %-10s %-17s %s\n", - "-", "-", ip_addr_str); + vshPrint(ctl, " %-10s %-17s %s\n", + "-", "-", ip_addr_str); virBufferFreeAndReset(&buf); VIR_FREE(ip_addr_str); -- 1.8.3.1