From: Michal Privoznik <mprivozn@redhat.com> There are some features/improvements/bug fixes I've either contributed or reviewed/merged. Document them for upcoming release. Signed-off-by: Michal Privoznik <mprivozn@redhat.com> --- NEWS.rst | 23 +++++++++++++++++++++++ 1 file changed, 23 insertions(+) diff --git a/NEWS.rst b/NEWS.rst index 56e344776b..699077afd6 100644 --- a/NEWS.rst +++ b/NEWS.rst @@ -39,10 +39,33 @@ v12.3.0 (unreleased) VM's interfaces (accessible via ``virsh domifaddr``) and the hostname of the VM (``virsh domhostname``). + * hyperv: Implement ``virDomainGetGuestInfo()`` + + The hyperv driver now implements API for fetching guest information + (``virsh guestinfo``). + * **Improvements** + * security: Don't error out on security labels of type='none' + + Previously, libvirt reported an error if a domain with seclabel of + type='none' (meaning do not take this security model into account for this + domain) was being started and the model wasn't available (for instance, in + case of SELinux it was disabled at boot). + * **Bug fixes** + * virnetdevmacvlan: Wait for udev to settle after creating macvtap + + When starting a domain with a macvtap device (or when hotplugging one), + libvirt creates the device and opens its ``/dev`` representation in order + to set it according to the ``<interface/>`` XML (e.g. MAC address, queues, + etc.). But if the system is under heavy load, it might happen that after + the device creation the udev daemon was triggered, but did not have enough + time to set the ``/dev`` representation fully. This may result in various + misconfiguration or even failed ``open()``. Therefore, libvirt waits after + device creation for udev daemon to settle down. + v12.2.0 (2026-04-01) ==================== -- 2.53.0