Shutting down the daemon after 30 seconds of being idle is a little bit too aggressive. Especially when using 'virsh' in single-shot mode, as opposed to interactive shell mode, it would not be unusual to have more than 30 seconds between commands. This will lead to the daemon shutting down and starting up between a series of commands. Increasing the shutdown timer to 2 minutes will make it less likely that the daemon will shutdown while the user is in the middle of a series of commands. Signed-off-by: Daniel P. Berrangé <berrange@redhat.com> --- src/remote/libvirtd.service.in | 2 +- src/rpc/virnetsocket.c | 2 +- 2 files changed, 2 insertions(+), 2 deletions(-) diff --git a/src/remote/libvirtd.service.in b/src/remote/libvirtd.service.in index 2e51429e7a..3ddf0e229b 100644 --- a/src/remote/libvirtd.service.in +++ b/src/remote/libvirtd.service.in @@ -25,7 +25,7 @@ EnvironmentFile=-/etc/sysconfig/libvirtd # VMs can be performed. We don't want it to stick around if # unused though, so we set a timeout. The socket activation # then ensures it gets started again if anything needs it -ExecStart=@sbindir@/libvirtd --timeout 30 $LIBVIRTD_ARGS +ExecStart=@sbindir@/libvirtd --timeout 120 $LIBVIRTD_ARGS ExecReload=/bin/kill -HUP $MAINPID KillMode=process Restart=on-failure diff --git a/src/rpc/virnetsocket.c b/src/rpc/virnetsocket.c index 34a9947eb3..3282bc0817 100644 --- a/src/rpc/virnetsocket.c +++ b/src/rpc/virnetsocket.c @@ -137,7 +137,7 @@ static int virNetSocketForkDaemon(const char *binary) { int ret; virCommandPtr cmd = virCommandNewArgList(binary, - "--timeout=30", + "--timeout=120", NULL); virCommandAddEnvPassCommon(cmd); -- 2.21.0