Add an entry about virt-host-validate bhyve support and update the driver's page. --- docs/drvbhyve.html.in | 13 ++++++++++++- docs/news.xml | 10 +++++++++- 2 files changed, 21 insertions(+), 2 deletions(-) diff --git a/docs/drvbhyve.html.in b/docs/drvbhyve.html.in index da6f1e0b2..64a1ff694 100644 --- a/docs/drvbhyve.html.in +++ b/docs/drvbhyve.html.in @@ -13,9 +13,20 @@ of bhyve are supported. In order to enable bhyve on your FreeBSD host, you'll need to load the <code>vmm</code> kernel module. Additionally, <code>if_tap</code> and <code>if_bridge</code> modules -should be loaded for networking support. +should be loaded for networking support. Also, <span class="since">since 3.2.0</span> the +<code>virt-host-validate(1)</code> supports the bhyve host validation and could be +used like this: </p> +<pre> +$ virt-host-validate bhyve + BHYVE: Checking for vmm module : PASS + BHYVE: Checking for if_tap module : PASS + BHYVE: Checking for if_bridge module : PASS + BHYVE: Checking for nmdm module : PASS +$ +</pre> + <p> Additional information on bhyve could be obtained on <a href="http://bhyve.org/">bhyve.org</a>;. </p> diff --git a/docs/news.xml b/docs/news.xml index 951539575..57fafebb8 100644 --- a/docs/news.xml +++ b/docs/news.xml @@ -12,7 +12,15 @@ <libvirt> <release version="v3.2.0" date="unreleased"> <section title="New features"> - <change/> + <change> + <summary> + virt-host-validate: Add bhyve support + </summary> + <description> + Add support for validation of the bhyve hypervisor hosts + using the virt-host-validate tool. + </description> + </change> </section> <section title="Improvements"> <change> -- 2.11.0