When changing the size of pipe that virFileWrapperFdNew() creates we start at 1MiB and if that fails because it's above the system wide limit we get EPERM and continue with half of the size. However, we might get another error in which case we should report proper system error and return failure from virFileWrapperFdNew(). Signed-off-by: Michal Privoznik <mprivozn@redhat.com> --- src/util/virfile.c | 18 +++++++++++------- 1 file changed, 11 insertions(+), 7 deletions(-) diff --git a/src/util/virfile.c b/src/util/virfile.c index 12b359d550..130b0fbace 100644 --- a/src/util/virfile.c +++ b/src/util/virfile.c @@ -217,7 +217,7 @@ struct _virFileWrapperFd { * * OS note: only for linux, on other OS this is a no-op. */ -static void +static int virFileWrapperSetPipeSize(int fd) { int sz; @@ -230,21 +230,24 @@ virFileWrapperSetPipeSize(int fd) continue; /* retry with half the size */ } if (rv < 0) { - break; + virReportSystemError(errno, "%s", + _("unable to set pipe size")); + return -1; } VIR_DEBUG("fd %d pipe size adjusted to %d", fd, sz); - return; + return 0; } VIR_WARN("unable to set pipe size, data transfer might be slow: %s", g_strerror(errno)); + return 0; } # else /* !__linux__ */ -static void +static int virFileWrapperSetPipeSize(int fd G_GNUC_UNUSED) { - return; + return 0; } # endif /* !__linux__ */ @@ -323,6 +326,9 @@ virFileWrapperFdNew(int *fd, const char *name, unsigned int flags) if (virPipe(pipefd) < 0) goto error; + if (virFileWrapperSetPipeSize(pipefd[output]) < 0) + goto error; + if (!(iohelper_path = virFileFindResource("libvirt_iohelper", abs_top_builddir "/src", LIBEXECDIR))) @@ -330,8 +336,6 @@ virFileWrapperFdNew(int *fd, const char *name, unsigned int flags) ret->cmd = virCommandNewArgList(iohelper_path, name, NULL); - virFileWrapperSetPipeSize(pipefd[output]); - if (output) { virCommandSetInputFD(ret->cmd, pipefd[0]); virCommandSetOutputFD(ret->cmd, fd); -- 2.34.1