https://bugzilla.redhat.com/show_bug.cgi?id=1022292 The following XML really does not make any sense: <inbound average="-1" burst="-2" peak="-3" floor="-4"/> There can't be a negative packet rate. Well, so far we haven't assigned any meaning to it. So reject it unless users harm themselves, because otherwise we turn the negative numbers into really big values. Signed-off-by: Michal Privoznik <mprivozn@redhat.com> --- src/conf/netdev_bandwidth_conf.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) diff --git a/src/conf/netdev_bandwidth_conf.c b/src/conf/netdev_bandwidth_conf.c index fdd5b7f..8824332 100644 --- a/src/conf/netdev_bandwidth_conf.c +++ b/src/conf/netdev_bandwidth_conf.c @@ -50,7 +50,7 @@ virNetDevBandwidthParseRate(xmlNodePtr node, virNetDevBandwidthRatePtr rate) floor = virXMLPropString(node, "floor"); if (average) { - if (virStrToLong_ull(average, NULL, 10, &rate->average) < 0) { + if (virStrToLong_ullp(average, NULL, 10, &rate->average) < 0) { virReportError(VIR_ERR_CONFIG_UNSUPPORTED, _("could not convert bandwidth average value '%s'"), average); @@ -68,21 +68,21 @@ virNetDevBandwidthParseRate(xmlNodePtr node, virNetDevBandwidthRatePtr rate) goto cleanup; } - if (peak && virStrToLong_ull(peak, NULL, 10, &rate->peak) < 0) { + if (peak && virStrToLong_ullp(peak, NULL, 10, &rate->peak) < 0) { virReportError(VIR_ERR_CONFIG_UNSUPPORTED, _("could not convert bandwidth peak value '%s'"), peak); goto cleanup; } - if (burst && virStrToLong_ull(burst, NULL, 10, &rate->burst) < 0) { + if (burst && virStrToLong_ullp(burst, NULL, 10, &rate->burst) < 0) { virReportError(VIR_ERR_CONFIG_UNSUPPORTED, _("could not convert bandwidth burst value '%s'"), burst); goto cleanup; } - if (floor && virStrToLong_ull(floor, NULL, 10, &rate->floor) < 0) { + if (floor && virStrToLong_ullp(floor, NULL, 10, &rate->floor) < 0) { virReportError(VIR_ERR_CONFIG_UNSUPPORTED, _("could not convert bandwidth floor value '%s'"), floor); -- 2.4.6