[PATCH] remote: conf: Mention that 'virtproxyd' doesn't require the '--listen' flag

'virtproxyd' doesn't have the '--listen' parameter and it's enough just to enable the corresponding option in the config. The config file is generic for all the daemons and we just omit/adjust some sections. Adding a separate mechanism to omit the note about the '--listen' parameter would be overkill so mention explicitly that it's required only for libvirtd and not virtproxyd. The section is omitted for other daemons. Resolves: https://bugzilla.redhat.com/show_bug.cgi?id=2094641 Signed-off-by: Peter Krempa <pkrempa(a)redhat.com&gt; --- src/remote/libvirtd.conf.in | 12 ++++++++---- 1 file changed, 8 insertions(+), 4 deletions(-) diff --git a/src/remote/libvirtd.conf.in b/src/remote/libvirtd.conf.in index defe6b83d0..929d3922e9 100644 --- a/src/remote/libvirtd.conf.in +++ b/src/remote/libvirtd.conf.in @@ -8,8 +8,10 @@ # # Flag listening for secure TLS connections on the public TCP/IP port. -# NB, must pass the --listen flag to the @DAEMON_NAME@ process for this to -# have any effect. +# +# To enable listening sockets with the 'libvirtd' daemon it's also required to +# pass the --listen flag on the commandline of the daemon. +# This is not needed with 'virtproxyd'. # # This setting is not required or honoured if using systemd socket # activation. @@ -21,8 +23,10 @@ #listen_tls = 0 # Listen for unencrypted TCP connections on the public TCP/IP port. -# NB, must pass the --listen flag to the @DAEMON_NAME@ process for this to -# have any effect. +# +# To enable listening sockets with the 'libvirtd' daemon it's also required to +# pass the --listen flag on the commandline of the daemon. +# This is not needed with 'virtproxyd'. # # This setting is not required or honoured if using systemd socket # activation. -- 2.36.1