Re: [libvirt] [PATCH for v5.3.0 10/17] security: Remember owner only for top level image
On 4/10/19 11:35 PM, Cole Robinson wrote:
On 3/28/19 11:04 AM, Michal Privoznik wrote:
> Here is the problem: If all disks had XATTRs (i.e. domains using
> them were started with owner remembering turned on) then
> refcounting implemented in XATTRs would work nicely and we could
> set the whole backing chain and restore it later. But world is
> not that simple. As soon as there is one domain that was started
> with the feature turned off (or simply by older libvirt), the
> XATTR refounting does not reflect the actual number of uses by
> running domains and therefore any attempt to restore might cut
> off the old domain.
>
> There is no simple way around this. Except artificially turning
> the feature off for the rest of the backing chain.
>
Is there a thread discussing the issues that led to disabling this code?
I looked but couldn't find one. I could use some more context on what
case this patch fixes, and the upcoming patches. I'm having trouble
groking these comments
I don't think I discussed it on the list. But imagine there are two
domains: vm1 and vm2. Let them have one disk each like this:
vm1: disk1.qcow2 (RW) -> base.qcow2 (RO)
vm2: disk2.qcow2 (RW) -> base.qcow2 (RO)
(I never know which way to draw the arrows, but I'm sure you get the
idea. base.qcow2 is shared between the domains)
Now, start only vm1. This means that both disk1.qcow2 and base.qcow2 are
relabelled. And imagine that seclabel remembering is on. The paths then
have some XATTRs on them where original owner is stored. So far so good.
But then the vm2 is started with seclabel remembering turned off (e.g.
it's on a different host and base.qcow2 is on shared NFS, or simply
sysadmin turned the feature off and restarted libvirtd).
Okay, we have two domains running, base.qcow2's refcount would be 1 (as
read from XATTRs) even though it's used by two domains. But leave that
aside for a moment.
Now, vm1 is shut down. The label restore is started. Because the domain
had the feature on when starting it up (it remembers that in the status
XML), the whole backing chain would be restored (btw turning the feature
off affects only freshly started domains). So we start with disk1.qcow2.
It's refcount is 1 and therefore the original owner is restored. Then we
proceed to base.qcow2. It's refcount is again 1 (as read from XATTRs)
and thus we restore its original owner. But this is problematic, becuase
that operation possibly cuts off vm2's access.
Well, if the refcounter of base.qcow2 would reflect the actual number of
times the file is in use then we'd have no problem - restore wouldn't be
done there, merely just refcounter update. But the refcounter only shows
how many times the file is in use by domains with the feature enabled.
Hopefully, this makes it clearer.
I can't think of a clever way around this. Any other than remembering
only the top layer and leaving the rest of the backing chain alone. This
feels like solving a cluster problem to me.
Michal