Hi Cédric, I have tested it, it works well. But the interface name will repeat 2 times. Please help to confirm this, and if below test for a single port host is enough? # cat /proc/sys/net/ipv6/conf/enp0s25/accept_ra 1 enable network default with ipv6 ip section # virsh net-start default error: Failed to start network default error: internal error: Check the host setup: enabling IPv6 forwarding with RA routes without accept_ra set to 2 is likely to cause routes loss. Interfaces to look at: enp0s25, enp0s25 # echo 2 > /proc/sys/net/ipv6/conf/enp0s25/accept_ra # virsh net-start default Network default started try create: # virsh net-create default.xml error: Failed to create network from default.xml error: internal error: Check the host setup: enabling IPv6 forwarding with RA routes without accept_ra set to 2 is likely to cause routes loss. Interfaces to look at: enp0s25, enp0s25 On Wed, Mar 15, 2017 at 10:45 PM, Cédric Bosdonnat <cbosdonnat@suse.com> wrote:
Hi Laine, all,
Here is the v2 of my series. The changes are:
* Add a commit to create a virNetDevGetName() function * Fix Laine's comments
Cédric Bosdonnat (5): util: extract the request sending code from virNetlinkCommand() util: add virNetlinkDumpCommand() bridge_driver.c: more uses of SYSCTL_PATH util: add virNetDevGetName() function network: check accept_ra before enabling ipv6 forwarding
src/libvirt_private.syms | 3 + src/network/bridge_driver.c | 25 ++++--- src/util/virnetdev.c | 19 ++++++ src/util/virnetdev.h | 2 + src/util/virnetdevip.c | 158 ++++++++++++++++++++++++++++++ ++++++++++++++ src/util/virnetdevip.h | 1 + src/util/virnetlink.c | 145 ++++++++++++++++++++++++++++++ ---------- src/util/virnetlink.h | 9 +++ 8 files changed, 319 insertions(+), 43 deletions(-)
-- 2.11.0
-- libvir-list mailing list libvir-list@redhat.com https://www.redhat.com/mailman/listinfo/libvir-list
-- Best Regards, Yalan Zhang IRC: yalzhang Internal phone: 8389413