Re: [libvirt] [PATCHv3 8/8] Add document for new command numatune.

On 12/15/2011 03:50 AM, Hu Tao wrote: This should be squashed in with 7/8. I would swap these two. Spacing. Document --live and friends. I'm using this instead: diff --git i/tools/virsh.pod w/tools/virsh.pod index 05c7f99..085f3aa 100644 --- i/tools/virsh.pod +++ w/tools/virsh.pod @@ -832,18 +832,23 @@ migrated to another host. Get the maximum migration bandwidth (in Mbps) for a domain. -=item B<numatune> I<domain> -[I<--nodeset nodeset>] [I<--mode mode>] +=item B<numatune> I<domain> [I<mode>] [I<nodeset>] [[I<--config>] [I<--live>] | [I<--current>]] -Set or get domain's numa parameters. +Set or get a domain's numa parameters, corresponding to the <numatune> +element of domain XML. -I<nodeset> is a list of numa node.Its syntax is a comma separated list -and a special markup using '-' and '^' (ex. '0-4', '0-3,^2') can also -be allowed. The '-' denotes the range and the '^' denotes exclusive. -I<mode> can be one of `strict', `interleave' and `preferred'. -For running domains(aka with I<--live>), the mode can't be changed, -and the nodeset can be changed only when the mode is `strict'. +I<mode> can be one of `strict', `interleave' and `preferred'. For a +running domain, the mode can't be changed, and the nodeset can be +changed only if the domain was started with a mode of `strict'. + +I<nodeset> is a list of numa nodes used by the host for running the domain. +Its syntax is a comma separated list, with '-' for ranges and '^' for +excluding a node. + +If I<--live> is specified, set scheduler information of a running guest. +If I<--config> is specified, affect the next boot of a persistent guest. +If I<--current> is specified, affect the current guest state. =item B<reboot> I<domain-id> -- Eric Blake eblake(a)redhat.com +1-919-301-3266 Libvirt virtualization library http://libvirt.org