Hi

 

I am creating macvtap0 interface on my eth1 interface.

ip link show macvtap0

133: macvtap0@eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UNKNOWN qlen 500

    link/ether 3e:63:18:f3:49:63 brd ff:ff:ff:ff:ff:ff

 

guest interface file-

 

<interface type='direct'>

      <mac address='3e:63:18:f3:49:63'/>

      <source dev='eth0' mode='bridge'/>

      <model type='virtio'/>

      <address type='pci' domain='0x0000' bus='0x00' slot='0x02' function='0x0'/>

    </interface>

Now when I do-

Virsh define guest works fine

But when I do virsh start guest

 

Dmesg shows error

 

macvtap0:no ipv6 routers present

libvirtd[24907]: segfault at 0 ip 0000003e22280062 sp 00007fd3057f8cb8 error 4 in libc-2.12.so[3e22200000+187000]

and even if guest starts its eth interface is not created

DISCLAIMER: 
----------------------------------------------------------------------------------------------------------------------- 
The contents of this e-mail and any attachment(s) are confidential and
intended 
for the named recipient(s) only.  
It shall not attach any liability on the originator or NECHCL or its 
affiliates. Any views or opinions presented in  
this email are solely those of the author and may not necessarily reflect the 
opinions of NECHCL or its affiliates.  
Any form of reproduction, dissemination, copying, disclosure, modification, 
distribution and / or publication of  
this message without the prior written consent of the author of this e-mail is 
strictly prohibited. If you have  
received this email in error please delete it and notify the sender 
immediately. . 
-----------------------------------------------------------------------------------------------------------------------

--
libvir-list mailing list
libvir-list@redhat.com
https://www.redhat.com/mailman/listinfo/libvir-list