[libvirt] [PATCH 5/5] docs: Correct typos in scsi hostdev and address elements

The type='scsi' parameter of an address element is ignored if placed within a hostdev section, and rejected by the XML schema used by virt-xml-validate. Remove it from the doc, and correct a typo in the remaining address arguments. Signed-off-by: Eric Farman <farman(a)linux.vnet.ibm.com&gt; Reviewed-by: Matthew Rosato <mjrosato(a)linux.vnet.ibm.com&gt; Reviewed-by: Stefan Zimmermann <stzi(a)linux.vnet.ibm.com&gt; Reviewed-by: Boris Fiuczynski <fiuczy(a)linux.vnet.ibm.com&gt; --- docs/formatdomain.html.in | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/docs/formatdomain.html.in b/docs/formatdomain.html.in index c88c4a6..f97a049 100644 --- a/docs/formatdomain.html.in +++ b/docs/formatdomain.html.in @@ -2839,7 +2839,7 @@ <dd>Drive addresses have the following additional attributes: <code>controller</code> (a 2-digit controller number), <code>bus</code> (a 2-digit bus number), - <code>target</code> (a 2-digit bus number), + <code>target</code> (a 2-digit target number), and <code>unit</code> (a 2-digit unit number on the bus). </dd> <dt><code>type='virtio-serial'</code></dt> @@ -3148,7 +3148,7 @@ &lt;hostdev mode='subsystem' type='scsi' sgio='filtered' rawio='yes'&gt; &lt;source&gt; &lt;adapter name='scsi_host0'/&gt; - &lt;address type='scsi' bus='0' target='0' unit='0'/&gt; + &lt;address bus='0' target='0' unit='0'/&gt; &lt;/source&gt; &lt;readonly/&gt; &lt;address type='drive' controller='0' bus='0' target='0' unit='0'/&gt; -- 1.9.1