Re: [libvirt] [PATCH] virsh: Clarify behavior of domain list filtering.

Some combinations of filtering flags produce no result. This patch tries to clarify this. Also fix unintentional double space. --- tools/virsh.pod | 11 ++++++----- 1 file changed, 6 insertions(+), 5 deletions(-) diff --git a/tools/virsh.pod b/tools/virsh.pod index c6f205a..2efb277 100644 --- a/tools/virsh.pod +++ b/tools/virsh.pod @@ -395,10 +395,11 @@ into s3 state. Normally only active domains are listed. To list inactive domains specify I<--inactive> or I<--all> to list both active and inactive domains. -To filter the list of domains present on the hypervisor you may specify one or -more of filtering flags supported by the B<list> command. These flags are -grouped by function. Specifying one or more flags from a group enables the -filter group. Supported filtering flags and groups: +To further filter the list of domains you may specify one or more of filtering

+flags supported by the B<list> command. These flags are grouped by function. +Specifying one or more flags from a group enables the filter group. Note that +some combinations of flags may yield no results. Supported filtering flags and +groups: =over 4 @@ -435,7 +436,7 @@ domains without a snapshot I<--without-snapshot>. When talking to older servers, this command is forced to use a series of API calls with an inherent race, where a domain might not be listed or might appear more than once if it changed state between calls while the list was being -collected. Newer servers do not have this problem. +collected. Newer servers do not have this problem. If I<--managed-save> is specified, then domains that have managed save state (only possible if they are in the B<shut off> state, so you need to specify