[libvirt] [PATCHv2 0/6] interface: udev backend bond support
Refactor code, clean up error handling, and finally add bond support. The
last patch optionally supports a patch I submitted to the Linux kernel
which should go in for 3.9 (it was just accepted for net-next).
After this patch when you have a bond device you'll get the following:
$ ./tools/virsh iface-dumpxml br0
<interface type='bridge' name='br0'>
<mtu size='1500'/>
<bridge stp='on' delay='1499'>
<interface type='bond' name='bond0'>
<mtu size='1500'/>
<bond mode='balance-rr'>
<interface type='ethernet' name='eth2'>
<mac address='d0:67:e5:fa:88:95'/>
<mtu size='1500'/>
</interface>
<interface type='ethernet' name='eth3'>
<mac address='d0:67:e5:fa:88:95'/>
<mtu size='1500'/>
</interface>
</bond>
</interface>
<!-- incorrectly including guest tap devices, but was an issue
prior and will be fixed in a later series -->
</bridge>
</interface>
Doug Goldstein (6):
interface: Refactor udev bridge to helper func
interface: udev bridge code error handling updates
interface: Refactor interface vlan to helper func
interface: Improve udev backend device type id
interface: add bond support to udev backend
interface: dev type support for bond interfaces
src/interface/interface_backend_udev.c | 546 +++++++++++++++++++++++++++------
1 file changed, 451 insertions(+), 95 deletions(-)
--
1.7.12.4