Re: [libvirt] Is it a workqueue related issue in 2.6.37 (Was: Re: blkio cgroup [solved])

On Fri, Feb 25, 2011 at 08:24:15AM +0100, Dominik Klein wrote: > > Maybe watching what the workqueue is doing using the following trace > > events could be helpful. > > > > # grep workqueue /sys/kernel/debug/tracing/available_events > > workqueue:workqueue_insertion > > workqueue:workqueue_execution > > workqueue:workqueue_creation > > workqueue:workqueue_destruction > > Since I've never done this before, I will tell you how I captured the > trace so you know what I did and can see whether I did something wrong > and can correct me if necessary. > > echo blk > /sys/kernel/debug/tracing/current_tracer > echo 1 > /sys/block/sdb/trace/enable > echo workqueue_queue_work >> /sys/kernel/debug/tracing/set_event > echo workqueue_activate_work >> /sys/kernel/debug/tracing/set_event > echo workqueue_execute_start >> /sys/kernel/debug/tracing/set_event > echo workqueue_execute_end >> /sys/kernel/debug/tracing/set_event > cat /sys/kernel/debug/tracing/trace_pipe Just an FYI, If you download trace-cmd from: git://git.kernel.org/pub/scm/linux/kernel/git/rostedt/trace-cmd.git You could do the following: # trace-cmd record -p blk -e workqueue_queue_work -e workqueue_activate_work -e workqueue_execute_start -e workqueue_execute_end <cmd> Where <cmd> could be sh -c "echo 1 > /sys/block/sdb/trace/enable; sleep 10" This will create a trace.dat file that you can read with trace-cmd report Another way, if you want to do more than just that echo is to use: # trace-cmd start -p blk -e workqueue_queue_work -e workqueue_activate_work -e workqueue_execute_start -e workqueue_execute_end # echo 1 > /sys/block/sdb/trace/enable # <do anyting you want> # trace-cmd stop # trace-cmd extract The start just enable ftrace (like you did with the echos). The extract will create the trace.dat file from the ftrace ring buffers. You could alse just cat trace_pipe, which would do the same, or you could do the echos, and then the trace-cmd stop and extract to get the file. It's your choice ;) You can then gzip the trace.dat file and send it to others that can read it as well, as all the information needed to read the trace is recorded in the file. You could even send the data over the network instead of writing the trace.dat locally. On another box: $ trace-cmd listen -p 12345 Then on the target: # trace-cmd record -N host:12345 ... This will send the data to the listening host and the file will be created on the host side.