I try to build from tarball.
That¡¯s all right )
Thank you!
From: Komarov Egor
Sent: Thursday, March 26, 2020 1:19 PM
To: Daniel P. Berrang¨¦
Cc: libvir-list@redhat.com
Subject: Re: Question: building libvirt into the buildroot. Error *** No rule to make target `keycodemapdb/data/keymaps.csv'
Thank you!
I'll try to build from tarball.
26 §Þ§Ñ§â. 2020 §Ô. 12:58 §á§à§Ý§î§Ù§à§Ó§Ñ§ä§Ö§Ý§î "Daniel P. Berrang¨¦" <berrange@redhat.com> §ß§Ñ§á§Ú§ã§Ñ§Ý:
On Thu, Mar 26, 2020 at 09:53:06AM +0000, Komarov Egor wrote:
> I'm using command from README
>
> $ mkdir build && cd build
> $ ../configure --prefix=/usr --sysconfdir=/etc --localstatedir=/var
> $ make
> $ sudo make install
This assumes someone is building from an official released tarball,
if building from git extra steps are required.
I think you're running more than that already, because the build log
you attached shows you've run libtoolize / autoconf / automake as well,
possibly via autoreconf. This is the bit you need to replace with
autogen.sh
>
> I don't have anything place where I can see how to build libvitd exept README from git archive.
>
> If you put me documentation where I can find your advice:
>
> " you have not run autogen.sh, and thus are missing initilaization of the
> git submodules."
More details on building from git are here:
https://libvirt.org/compiling.html#building
Regards,
Daniel
--
|: https://berrange.com -o-
https://www.flickr.com/photos/dberrange :|
|: https://libvirt.org -o-
https://fstop138.berrange.com :|
|: https://entangle-photo.org -o-
https://www.instagram.com/dberrange :|