Hello, I would like to set a specify default gateway for my VMs. However I’m not succeeding Here after is the isolated lan, where I added the statement <route address='10.0.0.0' prefix='8' gateway='10.10.0.7’/> where my aim is to route to the 10.10.0.7 What should I do , to make it works ? Thanks <network> <name>prd-private-lan</name> <uuid>255083f4-05a1-4a24-bc66-d3a3a9ab0724</uuid> <bridge name='virbr3' stp='off' delay='0'/> <mac address='52:54:00:08:1e:d8'/> <domain name='prd.pipiche.net'/> <dns> <forwarder addr='8.8.4.4'/> <forwarder addr='8.8.8.8'/> </dns> <ip address='10.10.0.1' netmask='255.255.255.0'> <dhcp> <range start='10.10.0.128' end='10.10.0.254'/> <host mac='52:54:10:b6:35:ca' ip='10.10.0.3'/> <host mac='52:54:10:5f:92:05' ip='10.10.0.7'/> <host mac='52:54:10:7d:3a:3f' ip='10.10.0.10'/> <host mac='52:54:10:30:93:56' ip='10.10.0.21'/> <host mac='52:54:10:78:c1:c2' ip='10.10.0.22'/> <host mac='52:54:10:64:00:21' ip='10.10.0.25'/> <host mac='52:54:10:5a:5f:63' ip='10.10.0.26'/> <host mac='52:54:10:4c:b2:61' ip='10.10.0.27'/> <host mac='52:54:10:62:de:5f' ' ip='10.10.0.62'/> </dhcp> </ip> <route address='10.0.0.0' prefix='8' gateway='10.10.0.7'/> </network> When looking on the VM (guest) the route is not correctly set route Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 10.10.0.0 0.0.0.0 255.255.255.0 U 100 0 0 ens4 arp -a ? (10.10.0.1) at 52:54:00:08:1e:d8 [ether] on ensue ifconfig ens4: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500 inet 10.10.0.27 netmask 255.255.255.0 broadcast 10.10.0.255 inet6 fe80::5054:10ff:fe4c:b261 prefixlen 64 scopeid 0x20<link> ether 52:54:10:4c:b2:61 txqueuelen 1000 (Ethernet) RX packets 1805 bytes 153644 (150.0 KiB) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 1745 bytes 136075 (132.8 KiB) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0