After years of finger training, I'm so used to 'make check' just working, that I lose quite a bit of time re-learning that in this project, it is spelled 'python setup.py build check'. A shim makefile bridges the gap. * Makefile: New file. Signed-off-by: Eric Blake <eblake(a)redhat.com&gt; --- I'd like to add this to the repo, but even if it gets rejected, I'll still keep it in my local tree :) Makefile | 18 ++++++++++++++++++ 1 file changed, 18 insertions(+) create mode 100644 Makefile diff --git a/Makefile b/Makefile new file mode 100644 index 0000000..6c8da0a --- /dev/null +++ b/Makefile @@ -0,0 +1,18 @@ +# Shim wrapper around setup.py to allow for familiar build targets + +PYTHON ?= python + +all: + $(PYTHON) setup.py build + +install: all + $(PYTHON) setup.py install + +clean: + $(PYTHON) setup.py clean + +check: all + $(PYTHON) setup.py test + +rpm: + $(PYTHON) setup.py rpm -- 1.9.3