Re: [libvirt] [PATCHv5 10/23] blockjob: support pivot operation on cancel

This is the bare minimum to end a copy job (of course, until a later patch adds the ability to start a copy job, this patch doesn't do much in isolation; I've just split the patches to ease the review). This patch intentionally avoids SELinux, lock manager, and audit actions. Also, if libvirtd restarts at the exact moment that a 'drive-reopen' is in flight, the only proper way to detect the outcome of that 'drive-reopen' would be to first pass in a witness fd with 'getfd', then at libvirtd restart, probe whether that file is still empty. This patch is enough to test the common case of success when used correctly, while saving the subtleties of proper cleanup for worst-case errors for later. When a mirror job is started, cancelling the job safely reverts back to the source disk, regardless of whether the destination is in phase 1 (streaming, in which case the destination is worthless) or phase 2 (mirroring, in which case the destination is synced up to the source at the time of the cancel). Our existing code does just fine in either phase, other than some bookkeeping cleanup. Pivoting the job requires the use of the new 'drive-reopen' command. Here, failure of the command is potentially catastrophic to the domain, since the initial qemu implementation rips out the old disk before attempting to open the new one; qemu will attempt a recovery path of retrying the reopen on the original source, but if that also fails, the domain is hosed, with nothing libvirt can do about it. If qemu 1.2 ever adds 'drive-reopen' inside 'transaction', then the problem will no longer exist (a transaction promises not to close the old file until after the new file is proven to work), at which point we would add a VIR_DOMAIN_REBASE_COPY_ATOMIC that fails up front if we detect an older qemu with the risky drive-reopen. Interesting side note: while snapshot-create --disk-only creates a copy of the disk at a point in time by moving the domain on to a new file (the copy is the file now in the just-extended backing chain), blockjob --abort of a copy job creates a copy of the disk while keeping the domain on the original file. There may be potential improvements to the snapshot code to exploit block copy over multiple disks all at one point in time. And, if 'block-job-cancel' were made part of 'transaction', you could copy multiple disks at the same point in time without pausing the domain. This also implies we may want to add a --quiesce flag to the pivot operation, so that when breaking a mirror, the side of the mirror that we are abandoning is at least in a stable state with regards to guest I/O. * src/qemu/qemu_driver.c (qemuDomainBlockJobAbort): Accept new flag. (qemuDomainBlockPivot): New helper function. (qemuDomainBlockJobImpl): Implement it. --- was 11/18 in v4 v5: no real change, improve commit message src/qemu/qemu_driver.c | 106 +++++++++++++++++++++++++++++++++++++++++++++++- 1 files changed, 105 insertions(+), 1 deletions(-)